1, the bonding layer thickness: general use of cement mortar bonding layer thickness of 10 ~ 25mm; high layer level lines come forward to put a brick laying thickness 3 ~ 4mm appropriate, laid out with a large bar Calibrating ruler, then leveling with trowel tapped (laying area not too large); 2, the bonding layer mixing: dry hard mortar, with the ratio of 1:3 (by volume), should vary the mix with the use, before the initial setting run, Inner Mongolia square color Trail brick mold, prevent affect the bond quality. Dry extent hard to hand shape into groups, Tibet color trails brick mold, floor powder that is appropriate. 3, dial the seam, trimming: Puwan two to three rows, the cable should always check the seam of the grid almost straight, as beyond the provisions should immediately trim the seam dial straight and tapped with a rubber hammer. The company has advanced plastic mold production lines and supporting professional machinery manufacturing, Shanxi grass color trails brick mold, business in a professional, dedicated and entrepreneurial spirit, the development of several major categories, hundreds of varieties of plastic molds. Brick path plastic mold requirements are: ① can produce various shape, size, appearance, physical properties, mechanical properties can meet the required qualified plastic parts ② automatic efficient and easy to operate. ③ reasonable structure, easy manufacture, low tooling cost. ④ trim and secondary processing workload plastic parts can be minimized. Structure and choice of materials ⑤ mold should be able to meet the requirements of life.