The company has advanced plastic mold production lines and supporting professional machinery manufacturing, colored pavement brick mold, business in a professional, dedicated and entrepreneurial spirit, the development of several major categories, hundreds of varieties of plastic molds. Brick path plastic mold requirements are: ① can produce various shape, size, appearance, physical properties, mechanical properties can meet the required qualified plastic parts ② automatic efficient and easy to operate. ③ reasonable structure, easy manufacture, low tooling cost. ④ trim and secondary processing workload plastic parts can be minimized. Structure and choice of materials ⑤ mold should be able to meet the requirements of life. 1, the bonding layer thickness: general use of cement mortar bonding layer thickness of 10 ~ 25mm; high layer level lines come forward to put a brick laying thickness 3 ~ 4mm appropriate, laid out with a large bar Calibrating ruler, then leveling with trowel tapped (laying area not too large); 2, the bonding layer mixing: dry hard mortar, with the ratio of 1:3 (by volume), should vary the mix with the use, before the initial setting run, to prevent the impact sticky knot quality. Dry hard level to hand shape into groups, floor powder that is appropriate. 3, dial the seam, trimming: Puwan two to three lines, square pavement brick mold should always check cable stitch grid almost straightness, Cangzhou pavement brick mold, such as beyond the provisions should immediately trim the seam dial straight, and with a rubber hammer tapped.